+86 0769 86066062 info@kehuimold.com

Heating Element and Hot Runner System

Heating Element and Hot Runner System
Name
Analysis and Explanation of Heating Element and Hot Runner System
hot runner system Heating the runner during injection to keep the plastic in the runner in a high-temperature molten state
steel O-ring Used for sealing between the runner and the sprue bushing opening
hot manifold Runner plate for installing heater cartridges, thermocouples, and hot nozzles
high temp. insulator sheet Heat insulation plate (also called insulating plate) that prevents heat loss
riser pad  Spacer blocks that prevent heat transfer from the hot runner plate to the mold base
cernter support pad Spacer blocks between the hot runner plate center and A-plate
valve gate system The opening of hot nozzles is controlled by valves
sequential valve gate Controlling the opening/closing of multiple hot nozzles through cylinder actuation, achieving ideal weld-line-free plastic parts
geater nozzle Also called hot nozzle or heated nozzle
nozzle bush The part of the hot nozzle contacting the cavity, serving to fix the heated nozzle
heater sprue gate The part of the hot nozzle contacting the mold cavity
close pin Valve pin in the hot nozzle for sealing plastic
close pin band Guide bushing for the valve pin (also called pin guide bush (YUDO) or pin guide (DEM)
band heater Also called heating coil or heater wire
heater sheet Heating elements often installed on Mold Master hot runner plates
thermocouple For temperature detection (also called temperature probe or thermocouple wire)
extend nozzle  Connected to the front end of hot nozzles to extend nozzle length
heater shell Heating shell outside hot nozzles and runner plates (also called heating collar)
gate shell insulator Insulating collar around hot nozzle exterior for heat insulation
manifold heater Heating elements installed in the middle of runner plates (e.g., DME’s CHS series and ECH series)
heater puller Installed at heater cartridge ends for sealing
end plug Also called hot runner end plug
heater clamp For encapsulating and securing heater cartridges
water cooled gate insert Used for cooling hot nozzle tips (e.g., components provided by Mold Master)
back plate Component installed on hot runner plates to mate with machine nozzles (without heating elements)
temp control module Temperature control circuit board
main frame Refers only to the housing/enclosure for temperature control components
terminal mounting box Socket mounting bracket (also called power box)
power cable Wiring between power supply and temperature control box
mold power-thermocouple Temperature control and heating power wiring (only for connections between control box and mold)
power/signal adapter Includes power connectors and thermocouple connectors
power/signal connector Includes power sockets and thermocouple sockets
reflector sheet Parts used in HASCO hot runner systems (Z1064..)
accessory kit Assemblies used in HASCO hot runner systems (Z1067/…)
filter cartridge Parts for HASCO hot nozzles (Z109/…)
heater plate Components installed on the back of Mold Master hot runner plates for heating and temperature control
inlet extension Components in Mold Master systems that mate with machine nozzles on runner plates (with heating elements)

Factory Overview

Latest Post

Mold Materials
Injection Mold Materials Commonly Used in the Automotive Industry
Plastic Injection Mold
5 Points To Extend The Service Life Of Plastic Injection Mold
Injection Mold
How To Optimize Injection Mold To Reduce Production Cycles?
Mold Supplier
How To Choose The Right Mold Supplier In The Automotive Industry?

Call

+86-0769-86066062

Email

info@kehuimold.com

Service Time

9:00 AM – 10:00 PM